If you cant locate the levers by touch with your fingers, get down at eye level and look for small black levers.The drawer is held in place by two small positive lever releases located on the back corners of the drawer runners on both sides.These levers prevent the drawer from coming all the way loose from the mounting hardware.
To completely remove the drawer from the cabinet, its necessary to trip the levers with your fingers. Place your right thumb on the right top of the drawer at the very back directly opposite your left thumb. Let your index fingers go inside the metal runners screwed to the sides of the drawer. You should be able to feel a small plastic lever inside the runner. Hold the drawer with your thumbs on top; with your index fingers holding the levers up inside the runner, slide the drawer back into the receiving cabinet runners. Shaddy has also worked as a newspaper reporter and writer, and as a contributing writer for Bicycling Magazine. Shaddy began publishing in various magazines in 1992, and published a novel, Dark Canyon, in 2008. The majority of them install similarly, and two common types exist: under-mount and side-mount. Under-mount, or bottom-mount, slides are concealed when the drawer extends, while side-mounted slides tend to support more weight. Another type, with a single center mount, typically appears on cheap cabinets and provides less stability. Full-extension versions of bottom- and side-mount slides allow the drawer to pull completely out of the cabinet. Bottom-mount slides adapt to a wide variety of styles and measurements. With allowable tolerances of 12 inch between the drawer and face-frame, bottom-mount slides are ideal for replacing older wooden slides, as new additions to older cabinets without existing slides or as a component in new cabinets. Side-mounted slides are close-tolerance, meaning that there can be little variation in the cabinet, with no more than a 18-inch gap between the top of the drawer and the top of the cabinet opening. One end of each slide should be marked or stamped with the letters DR, DL, CR or CL. The slide stamped DR represents the right side of the drawer; DL marks the left side of the drawer; CR means the right side of the cabinet; and CL means the left side of the cabinet. The stamped letters typically appear on the front of the slide that is, the end facing the front of the drawer. Use the oval-shaped screw holes (one in front and one in back). Screw the slide marked CR to the horizontal rail on the right side of the cabinet drawer opening using two screws, centered in the oval-shaped screw holes in front and back. If no rail exists in the back, the slide utilizes a boot that attaches to the back of the cabinet. Fit the drawers slides into the cabinets slides, and push the drawer into the cabinet. Depending on manufacturer, the use of a square may be necessary to level the cabinet slide horizontally before screwing it to the side of the cabinet. Some varieties of side-mount slides screw to the side of the drawer flush along the bottom instead of centered. These slides typically contain only a C mark for cabinet and D mark for drawer. ![]() Center-mount slides are very forgiving, so expect some sideways movement. If drawers are sticky, rub, grind or seem loose, loosen the screws and tap the slides in the direction needed so that the drawer moves in and out smoothly. Kv 1300 Drawer Slides Driver To LiftModels of side-mount slides may have cam-operated levers that are operated with a screwdriver to lift or lower the slides. When the drawers operate smoothly, add the remaining screws to all the screw holes in the slides.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |